Kinetica G2C 32-bit 3D Printer Controller for Creality Ender 3 and CR-10 Series

Description

Upgrade your Creality Ender/CR-10 3D printer to RepRapFirmware the easy way.
The Kinetica G2C is a direct replacement for the Creality motherboard on Ender 3,4 and 5 and the CR-10 V1 series of printers that have a single extruder. Uses 4 Trinamic TMC2209 Stepper Drivers.
The Kinetica G2C is a 32 bit ARM based Motion controller for 3D printers, CNC Machines and Laser cutters. It runs on RepRapFirmware and is based on the DUET 2 Maestro and DUET 2 Wifi.
Configuration is easy using a text based config file loaded on the SD card, no need to upload firmware every time you make a change. Just edit the config file from your PC then reboot the board with the new config and you're done.
Use either USB, Wifi or Ethernet to communicate with your machine. Full featured web control page to control, print and monitor your machine remotely. Supports Ender/CR-10 stock LCD, RRD Full Graphic Smart LCD and the PanelDue TFT touch display .
Compact and powerful all in one solution. Use it on your next printer build.
Requires an SD card to operate and store configuration files
Features:
32BIT ATMEL ATSAM4S8C 120MHZ ARM processor.
Runs on RepRapFirmware
Supports Wifi or Ethernet Networking
4 Trinamic TMC2209 drivers
1 High Current Mosfet for Heat bed control
1 Mosfet for Hotend control
2 FAN Mosfets and 1 case fan (always on)
4 End stops and 3 Thermistor inputs
Supports Ender/CR-10 Stock LCD, RRD Graphic Smart LCD and PanelDue
Wide input high efficiency switching Power supply
Micro SD card slot built in
High current Terminal blocks
Protected analog inputs
What's in the box:
Kinetica G2C Controller Board with RepRap Firmware
Wifi Module(if selected)
LCD adapter board for stock Ender/CR-10 LCD
External Antenna with U.FL pigtail
Ethernet Module (If selected)